Peoria Roof Pros provides professional chimney flashing in Peoria, IL for residential and commercial properties across the central Illinois River valley. Chimneys leak more than any other part of a Peoria roof, and the reason differs by neighborhood. The old bluff houses have tall masonry stacks in soft common brick. The plateau subdivisions have framed chases wrapped in siding with a metal cap on top.
On a soft-brick stack the failure is rarely the flashing alone. The crown has cracked, the mortar has receded, the brick itself is absorbing water, and it freezes and spalls every winter. Reflashing that chimney without dealing with the crown and the joints buys about two seasons, and we will tell you that before you pay for it rather than after.
Done properly, the flashing is two pieces. Step flashing woven course by course up both sides, then a separate counter flashing cut into a saw kerf in the mortar joint and wedged, so the masonry can move and the roof can move without opening a path. Surface-mounted metal held on with sealant is a temporary repair that gets sold as a permanent one constantly.
Any chimney more than about thirty inches wide wants a cricket on its uphill side. Without one, the chimney acts as a dam, snow and debris pile against the back, and the water sits against brick all winter. We frame and flash the cricket as part of the job rather than treating it as an upgrade, because on a north-facing bluff slope it is not optional.
Framed chases on the newer houses fail at the cap and the counter flashing, and often at the siding-to-roof junction where a kickout flashing was never installed. That missing kickout dumps the whole valley of water into a wall cavity, and by the time it shows up inside there is sheathing to replace as well as flashing to fix. By the time that shows up inside there is sheathing to replace as well as flashing to fix.
If the chimney is dead, say so and let us take it out. A stack that vented a furnace which is now direct-vented is a leak source you are paying to maintain. We take it down below the roof deck, frame and sheathe the hole, then shingle straight across it. That is often the cheapest permanent answer anyone will offer you. That is frequently the cheapest permanent answer anybody will offer you on an old bluff house.
Our licensed and insured team brings the right materials and equipment to every job — ASTM D3161 Class F laminated shingles specified above the bluff rim and not below it, six fasteners per shingle where the standard schedule calls for four, high-wind starter strip cemented along the eaves and both rakes, hot-dipped galvanized drip edge screwed to the deck rather than hand-nailed, half-inch OSB re-decking laid over 1x6 board sheathing with skip gaps, 24-gauge standing seam panels roll-formed off site when a lot has no lay-out room — and backs the work with a written workmanship warranty. We serve Peoria and nearby communities including East Peoria, Peoria Heights, West Peoria, Bartonville.
What We Handle
Everything our chimney flashing in Peoria covers
One crew, one point of contact, and the full range of chimney flashing work in Peoria, IL. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing repair peoria il
- chimney leak repair peoria county
- step flashing repair peoria illinois
- chimney cricket installation peoria
- chimney crown repair peoria il
- counter flashing peoria county
- tuckpointing and flashing peoria
- chimney chase flashing peoria illinois
- chimney flashing east peoria
- masonry chimney leak peoria heights
- chimney removal below deck peoria
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Peoria services.
Materials, equipment and how we do chimney flashing
The difference between chimney flashing that lasts and chimney flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with ASTM D3161 Class F laminated shingles specified above the bluff rim and not below it, six fasteners per shingle where the standard schedule calls for four, high-wind starter strip cemented along the eaves and both rakes, hot-dipped galvanized drip edge screwed to the deck rather than hand-nailed, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Peoria job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the central Illinois River valley means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney flashing outside Peoria
Peoria Roof Pros covers Peoria and the surrounding communities of the central Illinois River valley. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney Flashing in East Peoria, IL — Tazewell County, population 22,484
- Chimney Flashing in Peoria Heights, IL — Peoria County, population 5,908
- Chimney Flashing in West Peoria, IL — Peoria County, population 4,263
- Chimney Flashing in Bartonville, IL — Peoria County, population 5,945
- Chimney Flashing in Bellevue, IL — Peoria County, population 1,878
- Chimney Flashing in Creve Coeur, IL — Tazewell County, population 4,934
Start on the Peoria Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Peoria Chooses Peoria Roof Pros
- ✓We look up the elevation and lot grade at your address before the appointment, because on the Peoria bluff the ground around the house predicts the cost of the roof better than the roof does.
- ✓The fastening specification changes by exposure zone. Six nails per shingle and cemented starter at both rakes on the plateau rim, and the standard schedule down on the valley floor where that load never arrives.
- ✓Staging is a named line item. Where the debris trailer sits, where material lands, and how far it is hand-carried are on the first page of the bid rather than found on tear-off morning.
- ✓We refuse coatings over steep-slope shingles outright, and we refuse tile conversions with no structural engineer's letter naming the load.
The standards behind chimney flashing
Quality here is not a matter of opinion — it is written down. The chimney flashing work we do in Peoria follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney flashing project in Peoria gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney flashing free estimate in Peoria, or request a quote and we'll get right back to you.